Table of Contents
Advertisement
To disarm the starter kill in active or passive mode, the user must press and hold the
button on the transmitter (or enable valet mode). The parking lights will flash twice.
UNLOCK
If the door locks option was installed, this will also unlock the doors.
To arm the starter kill in active or passive mode, the user must press and hold the
button on the transmitter. The parking lights will flash once. (If the door locks option was
installed, this will also lock the doors). In passive mode, the system will automatically arm
itself 1 or 3 minutes after the engine is shut down.
Lock Pulse Duration
(7/10
th
sec.
LOCK
programmed to give 7/10-sec.
pulses, or for a 7/10-sec.
UNLOCK
double-pulse disarm/unlock systems).
Engine Run Time
(4 / 15 / 25 min. – by default.) In
engine running for 4, 15 (default), or 25 minutes. In diesel mode the module can be set to 9,
20 (default) or 30 min.
Idle Mode
(
– by default.) When programmed, this option allows the user to engage the remote
ON
starter to take over the vehicle while it is already running. This option will keep the vehicle
running for the pre-programmed run time, or until it is shut down.
Resetting the Module (without the plug-in valet)
Resetting the module is not a required process. Most of the time, you can avoid resetting the
module by fixing the issue directly at the root of the cause.
To reset the module, without using the plug-in valet button:
1.
FLASH the hood pin switch.
2.
In ten seconds or less, press the brake pedal six times.
3.
The parking lights will flash 8 times confirming the reset.
On some vehicles, such as, BMW, and certain Volkswagens, etc., pressing the brake pedal
without the key in the Ignition
the brake pedal–manually jumping 12 volts, with a fused test lead, at the brake pedal switch.
Resetting the Module (with the use of the plug-in valet)
The system is equipped with a reset function that allows the installer to erase all transmitter
codes and return all programmed options to the factory default values.
To reset the module:
1.
FLASH the hood pin switch.
2.
Press the valet button (if the plug-in valet was installed) 6 times or more, until the
parking lights start to flash.
3.
The parking lights will flash 8 times confirming the reset.
P. 14
and
– by default.) The door lock pulse duration can be
UNLOCK
and
LOCK
pulse and two 1/4 -second
LOCK
mode the module can be programmed to keep the
GAS
Table 7
position, will not work and therefore you will need to hot wire
ON
Table 8
pulses (by default), 4-sec.
UNLOCK
AS-1414/ AS-1424
Installation Guide
LOCK
and
LOCK
pulses (used for
UNLOCK
Hide quick links:
Advertisement
Table of Contents
