LifeSpan TR1200i Owner's Manual page 27

Step 3: Handlebar Assembly
A. Rotate the handlebars down so they are positioned on top of the handlebar
posts. Secure the right and left handlebars to the support post using the 2
M8 x70L screws (B) provided in the hardware bag.
NOTE: Make sure that the wires on both sides are not pinched
in-between the handlebars and the handlebar post.
B. Rotate the console bracket (8) up in the back until it reaches its normal
operating position.
C. Place the left outside handlebar cover (9) next to the inside handlebar
cover (pre-attached). Position the (pre-attached) yellow rubber ring (X) to
fit between these handlebar covers allowing the plastic ridge to sit in the
groove of the blue rubber ring. Secure these three parts together using the
self-tapping screws (C), which are pre-installed in the outer cover. Repeat
this process on the other side with the right outside handlebar cover (10).
X
Assembling Your Treadmill
Yelllow Rubber Ring
M8 x 70L
(x2)
6mm Allen
Wrench
5mm Allen
Wrench w/
Phillips
M4 x 10L
Screw
PRE-INSTALLED
25