LifeSpan TR1200i Owner's Manual page 26

Assembling Your Treadmill
Step 1: Unpacking Treadmill
A. Cut packaging straps and
remove.
B. Remove the box top.
C. Remove small parts and
packaging material and unwrap parts.
D. Cut corners of the bottom box and remove all packaging material to begin
assembly. The treadmill can be assembled in the box. No need to pick the
treadmill up to remove it from box.
Step 2: Handlebar Support
Post Assembly
A. Remove the screw (A) and nut
(E) that are pre-assembled on
the frame from each side of
the base using the 6 mm Allen
Wrench and 17 mm Open
End Wrench provided in your
tool kit. These two screws will
prevent the handlebars from
rotating up into their upright
position.
Note: Make sure the wire har-
ness coming from the front of
the frame to the base of the
right handlebar support will not
be pinched when pivoting the
right handlebar support up into
position.
B. Stand the support posts and
handlebars up into their op-
erating position and re-attach
the screws (A) and nuts (E)
removed in step 2A. Tighten securely.
C. Attach the left (13) and right (14) base covers using a Phillips screwdriver
and 2 machine screws (G) on each side. The 4 base cover attaching screws
are located in the hardware bag.
24
handlebars
as you lift
13/17mm
Wrench
6mm Allen
Wrench
M4 x 10L M10 x 45L
Screw
Bolt & Nut
PRE-INSTALLED
Support