Table of Contents
Advertisement
3. Managing the Switch Stack
The switch stack provides the following methods to configure and monitor the switch stack as follows:
Making out of band management via RS-232 console port
Making in-band management via telnet interface over TCP/IP network
Making in-band management via web interface over TCP/IP network
Making in-band SNMP management over TCP/IP network
After making stack connection as the procedure described in section 2.9, it is required to do the system stack
configuration and IP configuration via web interface or telnet interface.
It is not necessary to perform any pre-configuration for each individual switch before they are connected via
stack ports.
Under the condition that all member switches in a stack are with factory default configuration, the following
default IP and username are used for stack management access.
IP address of the switch: 192.168.0.2 / 255.255.255.0
Default
Fixed Username: admin
No password
The switch uses local authentication instead of RADIUS authentication with factory defaults.
3.1 Stack Configuration
3.1.1 Stack Configuration via Web Interface
Start Web Browser
Start your browser software and enter the default IP address to which you want to connect. The IP address is
used as URL for the browser software to search the device.
URL:
Login to the switch stack
When browser software connects to the switch stack successfully, a Login screen is provided for you to login
to the device as the left display below:
http:/192.168.0.2/
-25-
Advertisement
Table of Contents
