Choosing A Bootp Request Mode - Nortel 2000 Using Manual

Table 11 IP Configuration/Setup screen fields (continued)
Field Description
In-Band Subnet The subnet address mask associated with the in-band IP address shown on the screen
Mask (see In-Band Switch IP Address field). Network routers use the subnet mask to
determine the network or subnet address portion of a host's IP address. The bits in the
IP address that contain the network address (including the subnet) are set to 1 in the
address mask, and the bits that contain the host identifier are set to 0.
Default Value
Range
Default Gateway The IP address of the default gateway.
Default Value
Range
IP Address to The IP address of the network device you want to ping. This field is not required for the
Ping operation of the stack. This field cannot use the same IP address used for the stack.
Default Value
Range
Start Ping Pings the selected network device when you choose Yes.
Default Value
Range
Ping Address Displays last IP address you pinged.
Stack UpTime Displays how long the stack has been up in 00:00:00 format, which is
hours:minutes:seconds.
Reset Count Displays how many times the stack has been reset.

Choosing a BootP request mode

The BootP Request Mode field in the IP Configuration screen allows you to
choose which method the switch uses to broadcast BootP requests:
• BootP When Needed
• BootP Always
• BootP Disabled
Chapter 3 Using the console interface 157
0.0.0.0 (no subnet mask assigned)
Four-octet dotted-decimal notation, where each octet is represented
as a decimal value, between 0 and 255, separated by a decimal
point
0.0.0.0 (no IP address assigned)
Four-octet dotted-decimal notation, where each octet is represented
as a decimal value, between 0 and 255, separated by a decimal
point
0.0.0.0 (no IP address assigned)
Four-octet dotted-decimal notation, where each octet is represented
as a decimal value, between 0 and 255, separated by a decimal
point
No
No, Yes
Using the Business Policy Switch 2000 Version 1.2