Configuring The Arn For Netboot And Directed Netboot - Nortel Passport ARN Routers Installation And Operating

This appendix describes how to configure the Passport ARN router for Netboot
and Directed Netboot, as follows:
Topic
Using the
Using the
Verifying your configuration
The
netboot.
•
•
To determine the appropriate
ARN at your site, contact your network administrator. (Your network
administrator has information on these commands in Configuring Passport
Remote Access.)
114200-E Rev 00
Configuring the ARN for Netboot and
ifconfig
command
bconfig
command
and
ifconfig bconfig
Use the i
command to configure the router initial IP interface to the
fconfig
network. You need this information to complete the procedure in "Continuing
with Netboot" on page 2-8.
Use the command to specify the location and name of the ARN
bconfig
software image file and the configuration file. You need this information to
complete the procedure in "Continuing with Directed Netboot" on page 2-10.
commands configure the ARN for netboot and directed
command and
ifconfig
Appendix A
Directed Netboot
Page
A-2
A-7
A-8
commands for the
bconfig
A-1