Connecting To The Aui - Nortel Passport ARN Routers Installation And Operating

Connecting to the AUI

The AUI interface provides broadband, baseband, fiber, and shielded twisted pair
(STP) support, depending on the transceiver and cables you use.
Caution: Connecting the ARN AUI interface directly to the AUI interface on
an Ethernet station violates IEEE 802.3 standards. The AUI interface is
designed only for connection to a transceiver.
To attach an Ethernet AUI transceiver (drop) cable to the AUI connector on an
Ethernet module:
1.
U
D
B1
1
ISDN BRI
DD
B2
withNT1
COM
2
RLSD
Serial
Figure 1-5. Connecting an AUI Cable
2.
3.
114200-E Rev 00
Connect an Ethernet AUI drop cable to the interface labeled AUI
(Figure 1-5).
The cable must have a 15-position D-SUB receptacle.
10BaseT
Tx
Rx
Cl
Ethernet 2
10BaseT
Tx
Rx
Cl
Ethernet 1
To
Ethernet
transceiver
Secure the AUI cable using the slide lock on the interface.
Connect the other end of the cable to an Ethernet transceiver.
Expansion module AUI interface
Base module AUI interface
RLSD3 COM3
AUI
RLSD4
RLSD5
AUI
Run Pwr Base Expansion
Boot RPS Adapter1 DCM
Diag Fan Adapter2 PCMCIA
Ethernet AUI drop cable
Installing the ARN
COM4 COM5
Serial
Advanced Remote Node
ARN0063A
1-11