Connecting The Power Cable - Nortel Passport ARN Routers Installation And Operating

Figure 1-24.

Connecting the Power Cable

Danger: Be sure that the power switch on the ARN back panel is in the OFF
(0) position before you connect the power cable.
To connect the power cable to the ARN, complete these steps:
1.
114200-E Rev 00
Back-panel V.34 Modem Interface
To
RJ-11 telephone
receptacle
Connecting to an Integrated Console Modem
Connect the power cable to the power connector on the left side of the
ARN back panel (Figure
Tx RLSD
Modem
DTR
Rx
Console
Modem
ARN0072A
1-25).
Installing the ARN
1-29