Table of Contents
Advertisement
RIP Worksheet
(continued)
Requested Information
Specify the version of RIP . The default
is to run RIP1. Rip2 runs RIP2 without
the automatic aggregation of subnets
that RIP1 provides. RIG2_AGGR
provices the automatic aggregation of
subnets for RIP2.
Enter Routing Protocol Number [1]:
OSPF Worksheet
Requested Information
Enter OSPF router ID in dotted
decimal notation:
Enter the OSPF area ID in dotted
decimal notation [0.0.0.0]:
Enable Simple Password
authentication? (y/n) [n]:
Follow default paths for unknown
subnets? (y/n) [n]:
114200-E Rev 00
Using Local Boot (the Quick-Start Procedure)
Options
1. RIP1
2. RIP2
3. RIP2_AGGR
Options
Enter an IP address to uniquely
identify the router in the OSPF
domain. The router provides the IP
address of the COM port.
We suggest using the default IP
address.
Enter the area ID. This ID must
match the area ID of the router's
neighbor.
Note: The backbone area ID is
always 0.0.0.0.
y(es)
n(o)
Note: If you answer y(es), the
router requests a password.
y(es)
n(o)
Your Response
Your Response
Password:
______________
(continued)
B-9
Advertisement
Table of Contents
