Nortel NN46120-104 User Manual page 57

3
Copyright © 2007-2008 Nortel Networks
.
or more VPN Gateways to a cluster that already contains four
master NVGs, each additional NVG is automatically configured
as slave.
It is recommended that there are 2-4 master NVGs in each
cluster, so in most cases there is no need to change the
default setting. If needed, you can always reconfigure a VPN
Gateway by changing the Type setting after the initial setup.
For more information, see the type command in the "iSD
Host Configuration" section under Configuration Menu>System
Configuration in the Command Reference.
Enter the type of this iSD (master/slave) [master]:
......ok
Wait until the Setup utility has finished.
Setup successful.
login:
The setup is now finished. The VPN Gateway that has been
joined to the cluster will automatically pick up all configuration
data from one of the already installed NVG(s) in the cluster. After
a short while you will get a login prompt.
If needed, you can now continue with the configuration of the
NVG cluster using the Command Line Interface (CLI) or the
Browser-Based Management Interface (BBI). Log in as the
admin user.
For more information about the CLI, see
Interface" (page 135).
For more information about the BBI, see the SSL VPN BBI Quick
Guide.
Nortel VPN Gateway
User Guide
NN46120-104 02.01 Standard
14 April 2008
Complete the Join Setup 57
"The Command Line
--End--