Nortel NN46120-104 User Manual page 55

3
4
5
6
7
Copyright © 2007-2008 Nortel Networks
.
Specify the port you want to use for management traffic. This
port will be assigned to an interface for management purposes
only (Interface 1).
Specify a host IP address on the management interface for
the current VPN Gateway.
Enter IP address for this machine (on management
interface): <IP address>
This IP address must be unique on the network and be within
the same network address range as the Management IP address
(see Step 9). The management interface host IP address will be
assigned to Interface 1.
Enter network mask and VLAN tag ID.
Enter network mask [255.255.255.0]: <Press ENTER if
correct>
Enter VLAN tag id (or zero for no VLAN) [0]: <VLAN tag
id or ENTER>
Specify the desired network mask for the host IP address on
the management interface or accept the suggested value by
pressing ENTER. If a connected router or switch attaches VLAN
tag IDs to incoming packets, specify the VLAN tag ID used.
Enter yes and press ENTER to continue with creating a
two-armed configuration.
Setup a two armed configuration (yes/no) [no]: yes
Specify a new port number for the traffic interface.
Enter port number for the traffic interface [1-4]: 2
The traffic interface port number will automatically be assigned
to Interface 2.
Specify a host IP address and network mask on the traffic
interface for the current VPN Gateway.
Enter IP address for this machine (on traffic
interface): <IP address>
Enter network mask [255.255.255.0]: <press ENTER to
accepts>
In a two-armed configuration, the traffic interface host IP address
will be assigned to Interface 2.
Nortel VPN Gateway
User Guide
NN46120-104 02.01 Standard
14 April 2008
Setting up a Two-Armed Configuration 55