Nortel NN46120-104 User Manual page 43

4
5
6
7
Copyright © 2007-2008 Nortel Networks
.
You can later use the /cfg/sys/host 1/interface 1
command to view the resulting settings for Interface 1.
Note: If needed, you can later create a two-armed
configuration by adding a new interface to the cluster,
exclusively used for client traffic, and assign an unused port
to that interface. For information about how to add a new
interface, see the "Interface Configuration " section under
Configuration Menu>System Configuration in the Command
Reference. For information about how to assign ports to an
interface, see the "Interface Ports Configuration " section in
the same chapter.
Enter network mask and VLAN tag ID.
Enter network mask [255.255.255.0]: <Press ENTER if
correct>
Enter VLAN tag id (or zero for no VLAN) [0]: <VLAN tag
id or ENTER>
Specify the desired network mask or accept the suggested value
by pressing ENTER. If a connected router or switch attaches
VLAN tag IDs to incoming packets, specify the VLAN tag ID
used.
Press ENTER to continue with creating a one-armed
configuration.
Setup a two armed configuration (yes/no) [no]: <Press
ENTER>
Enter a default gateway address.
Enter default gateway IP address (or blank to skip):
<gateway IP address>
Enter a default gateway IP address that is within the same
network address range as the host IP address configured in step
3.
Enter a Management IP address (MIP).
Enter a unique Management IP address (MIP) that is within the
same network address range as the host IP address and the
default gateway IP address.
Enter the Management IP (MIP) address: <IP address>
Making sure the MIP does not exist...ok
Trying to contact gateway...ok
Nortel VPN Gateway
User Guide
NN46120-104 02.01 Standard
14 April 2008
Setting Up a One-Armed Configuration 43