SynOptics 3395 Using Manual page 75

SHOW|LIST PORT
Characteristic
DSRlogout
DSRWait
Inactivity Logout
Input Flow Control
Internet Connections
Interrupts
Kerberos
Limited View
Line Editor
Loss Notification
Message Codes
Menu
Multisessions
Noloss
Output Flow Control
Password
Pause
PPP
Privileged Menu
3-50
Means
The terminal server logs out the port when the serial interface
DCD signal is deasserted.
The terminal server begins the login sequence at this port
when the DSR signal is asserted.
The terminal server logs out the port after the period of time if
you have not entered any commands at the port. The network
manager specifies the amount of time with the SERVER
INACTIVITY TIMER value.
This port uses flow control to regulate the flow of data from
the device connected to it.
The port can accept Internet addresses as well as domain names
in connect commands.
You can use the <Break> key or a local switch character to
interrupt a session at a remote terminal server.
The Kerberos security system is enabled at this port.
You cannot view destinations on the network with the
SHOW|LIST DESTINATIONS, NODES, or SERVICES
commands.
You can use editing characters at this port.
The terminal "beeps" if you enter a command line that exceeds
132 characters.
The port displays the number associated with status or error
messages.
This port uses a menu-driven interface.
This port uses multisessions.
This port stores data in a buffer while waiting for a session to
be established, then sends the data to the connections partner
when the session is established.
This port uses flow control to regulate the flow of data to the
device connected to it.
You must enter a password to log on to this port.
This port pauses when it sends data from display commands to
the terminal after it fills each screen.
The Point-to-Point Protocol is enabled at this port.
The port is privileged and uses the menu interface. (Not
visible to Secure users.)
893-386-B