SynOptics 3395 Using Manual page 56

[TELNET SYNCHRONIZE]
[TYPE]
[VERIFICATION]
893-386-B
[character]
Regain control of a Telnet process that you suspect
[NONE]*
is no longer functioning properly. When you use
this character or control character sequence. Most
Telnet hosts will return to the operating system
command prompt, although this is not always the
case. If NONE, do not enable a Telnet synchronize
character at this port. Use this keyword to disable a
previously defined Telnet synchronize character.
[ANSI]
Change the characteristic that affects how the
[HARDCOPY]
terminal server sends data to the terminal and how
[SOFTCOPY]*
the terminal displays that data. For terminals that
emulate several terminal types, this characteristic
should match the actual terminal setting. This
characteristic only affects the terminal when it runs
the Model 3395/3395A command processor.
ANSI
HARDCOPY
SOFTCOPY*
[ENABLED]*
Display status messages on the terminal screen
[DISABLED]
when you establish a session, disconnect from a
session, or switch a session.
Produce output for a video-display terminal
and support American Institute of
Standards (ANSI) escape sequences.
Generally, this characteristics applies to
terminals that support the clear screen
function and special cursor control
functions, but not line drawing. Typical
ANSI terminals are DEC VT100, VT200,
and VT300 terminals, or terminals
compatible with these types.
Produce output for a printing terminal or a
nonvideo-display terminal, or emulate a
printing terminal. Most hardcopy terminal
types produce output on paper. When you
delete characters on a hardcopy terminal,
they appear on the paper between two
backslash characters (\ \).
Produce output for a video-display terminal
that does not support ANSI escape
sequences. Softcopy terminal types echo
character deletions when you use the
<Delete> key, but do not support the clear
screen function, special cursor control
functions, or the line drawing function.
SET PORT
3-31