Frequently Used Programming Operations; Changing The Time And Date On The Display - Nortel P0857846 System Coordinator Manual

Frequently used
programming operations
The following sections highlight the most frequently used programming
operations. To consult these or other programming operations, see
either the Table of Contents or the Index.

Changing the time and date on the display

The passwords can be changed. See "Using passwords" on page 124 for
more information.
In this example, you are changing the time to 1:30 p.m.
If you are only changing the time and not the date, press
session.
In this example, you are changing the date to July 15, 1998.
P0857846 Issue 02
ƒ
Press .
••°›fl‹
••ÊȘ‰
Press
¤¤‡›¤
as
¤‹fl›fl ÅΘȈ
Press
(
Press CHANGE .
Press the dial pad buttons to enter the hour.
Use two digits for all hours. The clock on the
display will show either one or two digits.
The display will prompt you to choose a.m. or
p.m. Press CHANGE and
Press .
NEXT
Press CHANGE .
Press the dial pad buttons to enter the minutes.
Norstar-PLUS Modular ICS 2.0 System Coordinator Guide
(which is the same
ıÅÍÈÇ
).
( ) or
)
OK to select p.m.
®
to end your