Table of Contents
Advertisement
22. Noting the alignment dots, install the thermostat
cap with thermostat. Secure the cap with cap
screws and tighten to 96 in.-lb.
23. With new gaskets in place, install the reed valve
assemblies; then secure the intake flanges in a
crisscross pattern to 96 in.-lb.
52
24. Install the dowel pins into the crankcase; then
place the cylinder base gasket into position on the
crankcase.
25. Install the piston rings on each piston so the letter
on the top (inclined surface) of each ring faces the
dome of the piston.
FC134
Incorrect installation of the piston rings will result in
engine damage.
26. Apply oil to the connecting-rod small end bear-
ings; then install the small-end bearings. Install a
0742-304
washer on each side of the connecting rod.
NOTE: The shoulder side of the washer must
FC078A
seat to the needle bearing.
FC073
CAUTION
726-306A
TZ068
FC075
Advertisement
Table of Contents
