Arctic Cat Sno Pro 500 Operator's Manual page 46

NOTE: To ensure the cleanliness of the flywheel
magnets, place the flywheel (with the magnets fac-
ing upward) on a clean bench.
4. Remove the ignition timing sensor.
5. Remove the Allen-head cap screws securing the
stator to the stator plate. Move the stator to the
side to access the Phillips-head cap screw securing
the stator lead wire; then remove the cap screw.
6. Remove the stator plate from the engine.
40
CM013
NOTE: The stator plate screws had Loctite
applied to the threads during assembly. Using an
impact driver, apply a sharp blow to the head of
each screw to break the Loctite loose before
removal.
FC022
7. Remove the spark plugs.
8. Remove the cap screws with O-rings securing the
cylinder head; then separate from the cylinders.
Account for the O-rings.
9. Remove the oil-injection hose from each flange
and the crankcase nozzle.
FC018
NOTE: When removing the cylinders, place the
engine on its intake flanges on a drain tray to allow
residual coolant to drain from the cylinder/crank-
case water jacket.
FC021
FC065
FC026