IKEA FIXA Original Instructions Manual page 11

WARNING! Do not continue
to press the On/Off switch after the
machine has been automatically
switched off. The battery can be
damaged.
WARNING! Recharge the battery
on a non-flammable surface. Do not
recharge the battery for more than
eight hours. The red diode will turn green
when the battery has been fully loaded.
Disconnect the cable and store the
transformer in a suitable place when it is
not in use.
It is not advisable to recharge the battery
in temperatures below freezing.
When removing the battery from the
machine, actuate the On/Off switch
(6) until the battery is completely
discharged. Unscrew the screws in
the casing and take off the casing shell.
Disconnect the connections on the battery
and remove the battery (see figure B).
INSTRUCTIONS FOR USE
Changing the tool
The SDS plus tool holder allows for simple
and convenient changing of drilling tools
without the use of additional tools. Due to
their working principle, SDS plus drilling
tools move freely. This results in radial
runout at no-load. However, this has no
effect on the accuracy of the drill hole, as
the drill bit centres itself during drilling.
The SDS tool holder can also accommodate
different drill-bit types with hexagon
shank. The dust protection cap (2) largely
prevents the entry of drilling dust into
the tool holder during operation. When
inserting the tool, take care that the dust
protection cap (2) is not damaged.
Inserting SDS plus Drilling Tools (see
figure A)
Clean and lightly grease the shank end of
the tool.
Insert the tool in a twisting manner into
the tool holder until it latches itself.
Check the latching by pulling the tool.
Removing SDS plus Drilling Tools (See
figure A)
WARNING! Accessories may be
hot after use. Avoid contact with skin and
use proper protective gloves or cloth to
remove.
Push back the locking sleeve (3) and
remove the tool. All accessories should be
wiped clean after removing.
Dust/Chip Extraction
Dusts from materials such as lead-
containing coatings, some wood types,
minerals and metal can be harmful to
one's health. Touch ing or breathing-in the
dusts can cause aller gic reactions and/or
lead to respiratory infec tions of the user or
bystanders.
Certain dusts, such as oak or beech dust,
are considered as carcinogenic, especially
in connection with wood-treatment
additives (chromate, wood preservative).
Materials containing asbestos may only be
worked by specialists.
Provide for good ventilation of the work ing
place.
It is recommended to wear a P2 filter class
respirator.
10