Replacing A Power Supply - Compaq TA1000 Reference Manual

7-6 Compaq TA1000 Tape Drive Array Reference Guide

Replacing a Power Supply

2. Align the blower guide post 2 with power supply connector 1. Slide
the replacement blower 3 into blower base until the tabs 4 snap into
place.
1
Figure 7-4. Blower replacement
3. Make sure that the blower starts operating immediately and the blower
LED is On.
CAUTION: Removing a power supply significantly changes the airflow within
the tape array. The system could shut down because of overheating unless the
power supply is replaced within 5 minutes.
NOTE: Replacement power supply assemblies do not include a variable speed blower.
Therefore you must remove the operational blower from the defective power supply and
install it on the new supply.
To replace a power supply or a blower mounting assembly:
1. Disconnect the AC power cord from the defective supply.
2
4
4
3