Compaq TA1000 Reference Manual page 50

7-8 Compaq TA1000 Tape Drive Array Reference Guide
4. Remove the operational blower from the defective power supply by
pushing the two blower tabs 1 in and pulling the blower element to the
rear.
Figure 7-7. Removing the blower
CAUTION: Pressing on the center section of the blower can damage the blades.
Only press on the outer edge of the blower when installing the blower.
5. Install the blower on the replacement supply by aligning the blower
guide post 2 with power supply connector 1. Slide the blower 3 into
blower base until the tabs 4 snap into place.
1
Figure 7-8. Installing the replacement blower
1
2
4
1
4
3