Appendix D Power Cord Requirements; General Requirements - Compaq StorageWorks ESL9000 Series Reference Manual

The power cord set meets the requirements for use in the country where you purchased
your equipment. Power cord sets for use in other countries must meet the requirements of
the country where you use the server. For more information on power cord set
requirements, contact your authorized Compaq dealer.

General Requirements

The requirements listed below are applicable to all countries:
I
The length of the power cord must be at least 6.0 feet (1.8 m) and a maximum of 12
feet (3.7 m).
I
The power cord set must be approved by an acceptable accredited agency responsible
for evaluation in the country where the power cord will be used.
I
The power cord set must have a minimum current capacity and nominal voltage rating
of 20 A at 125 VAC, or 10 A at 250 VAC as required by each country's power system.
I
The appliance coupler must meet the mechanical configuration of an EN60320/IEC
320 Standard Sheet C13 Connector for mating with the appliance outlet on the server.
Power Cord Requirements
D
Appendix