Cable Dressing Of The Drive Unit - Pioneer MEP-7000 Service Manual

5

1.5 CABLE DRESSING OF THE DRIVE UNIT

How you dress the cables connected to the SJACK Assy greatly affects the sound quality from the unit. During
disassembly and reassembly of the drive unit, be careful of cable dressing. At the end of reassembly, be sure to
check that the cable dressing is performed as shown below.
For performance improvement, cable dressing methods have been changed several times in the middle of mass
production of this product.
During cable dressing of this product, be careful of the following points:
[1] When cables are disconnected from the SJACK Assy
CASE 1
When cables are disconnected from the DWX2710 :
CASE 2
When cables in the initial dressing state are disconnected from
the DWX2896 :
CASE 3
When cables in the temporary dressing state are disconnected
from the DWX2896 :
CASE 4
When cables in the permanent dressing state are disconnected
from the DWX2896 :
[2] When the SJACK Assy is replaced
CASE 5
When the DWX2710 is replaced with the DWX2896 :
CASE 6
When the DWX2896 in the initial cable dressing state is replaced :
CASE 7
When the DWX2896 in the temporary cable dressing state is
CASE 8
When the DWX2896 in the permanent cable dressing state is
5
6
See Fig .
See Fig .
See Fig .
See Fig .
See Fig .
See Fig .
replaced :
See Fig .
replaced :
See Fig .
6
7
It is essential that the cables be dressed as
they originally were.
Parts to be added during servicing :
FFC guard (DEC2586) &
Shield Sheet (DEC3151) &
Locking Mini Clamp (DEC2439)
Parts to be added during servicing :
FFC guard (DEC2586) &
Shield Sheet (DEC3151) &
Locking Mini Clamp (DEC2439)
Parts to be added during servicing :
Locking Mini Clamp (DEC2439)
Parts to be added during servicing :
None
MEP-7000
7
8
A
B
C
D
E
F
9
8