Pioneer MEP-7000 Service Manual page 13

5
Fig : Permanent cable dressing
D-OUT cables
Pass the D-OUT cables through
the slit of the Shield Sheet
D-OUT cables
Insert the locking mini clamp
(DEC2439, additional part)
in the hole of the board.
Cables for analog signals
5
6
Add the Shield Sheet
(DEC3151) and
FFC guard (DEC2586).
MEP-7000
6
7
How to attach the Shield Sheet and FFC guard
1. Align the edge of the
Sheet with that of the PCB
STAY Assy and the hole of the
Shield Sheet
locking mini clamp on the PCB
STAY Assy. Then paste the
Shield Sheet
Assy.
2. Attach the locking mini clamp.
3. Place the FFC guard in
contact with the clamp and
so that the clamp comes to
the middle of the FFC guard.
Pass the D-OUT cables
through the locking mini clamp.
USB cables
Tie the cables for analog signals
with the PCB binder at the base.
Push the cables down toward
the board so that they are
positioned as far from
the USB cables as possible.
7
8
A
Shield
with that for the
to the PCB STAY
B
C
D
E
F
13
8