Installing A Smart Storage Battery - HP HPE ProLiant ML30 Gen9 User Manual

Install the storage controller.
11.
Install the PCIe slot cover retainer.
12.
If you installed a cache module on the storage controller, connect the cache module cable to the
13.
system board connector. For cache module cabling information, see "FBWC module cabling
("FBWC
Connect all necessary cables to the storage controller and drive cage backplane. For internal drive
14.
cabling information, see "Storage cabling (on page 66)."
Install a front PCI fan
15.
Install the air baffle (on page 19).
16.
Install the access panel (on page 17).
17.
Install the bezel (on page 16).
18.
Return the server to an upright position.
19.
Connect each power cord to the server.
20.
Connect each power cord to the power source.
21.
Power up the server (on page 16).
22.

Installing a Smart Storage Battery

For more information about product features, specifications, options, configurations, and compatibility,
see the product QuickSpecs on the Hewlett Packard Enterprise website (http://www.hpe.com/info/qs).
To install the component:
Power down the server (on page 16).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Remove the bezel (on page 17).
3.
Place the server on its side with the access panel facing up.
4.
Remove the access panel (on page 18).
5.
Remove the air baffle (on page 20).
6.
cabling" on page 71)."
("Front PCI fan option" on page 25).
Hardware options installation 48