Remove the access panel (on page 18).
5.
Remove the air baffle (on page 20).
6.
Disconnect and remove the drive cage cable assembly.
7.
Disconnect the Mini-SAS cable from the system board.
a.
Disconnect the power cable from the power supply.
b.
Disconnect the drive cables from the rear of the drives.
c.
Remove the non-hot-plug drive cage.
8.
Install the drive cage assembly.
9.
Connect the drive backplane cables:
10.
Connect one end of the Mini-SAS cable to the backplane and the other end to the system board.
a.
Connect the power cable to the backplane.
b.
Hardware options installation 56