Numatic TTB 4055/100 Owner's Instructions Manual page 28

Filling the Clean-water Tank
The TTB Range are all equipped with a 40 litre clean-water tank allowing large areas to be cleaned in a single fill.
21
Great care must be taken to ensure that contaminants (leaves,hair, dirt, etc) are not allowed to enter the clean-water
tank during the filling process. If using a bucket or similar, ensure it is always clean and free from debris.
Control of Substances Hazardous to Health (COSHH)
For best results use a non-foaming type of chemical, dilute to the manufacturers specification.
For further guidance on hazardous substances refer to health and safety instructions online.
Visit http://www.hse.gov.uk/
!
Always ensure that chemical manufacturers safety guidelines are followed.
Only use chemicals recommended for use in auto scrubber-dryers.
22
Machine Set-Up
To fill the clean-water tank, use the FLEXI - FILL
pipe from either a tap or hose pipe (Fig.21).
The large cap can also be used for filling from a
bucket or suitable container.
Fill the clean-water tank to a maximum of 40 litres,
including cleaning chemicals if required.
Follow chemical manufacturing guide lines.
The clear dump hose at the rear of the
machine can be used to see the level of
the clean-water.
for UK information.
WHEN HANDLING AND MIXING CHEMICALS
MAX
Note:
Pre-cleaning advice
Before performing the cleaning operation, place out
appropriate warning signs and sweep or dust-mop the
floor (Fig.22).
Numatic part (629044) Wet Floor sign
28
(available if required)
!