Numatic TTB 4055/100 Owner's Instructions Manual page 20

Quick Set-Up Guide
!
AFTER THE REMOVAL OF ALL THE PACKAGING, CAREFULLY OPEN AND CHECK
THE CONTENTS. ENSURE THE BATTERIES ARE CHARGED BEFORE USE.
1
3
5
7
8
PLEASE READ BEFORE COMMENCING ANY OPERATION
Using the handle position lever
(Fig.1), move the handle into the
upright position (Fig.2).
Place 50 amp fuse (supplied in the accessory kit)
into the fuse holder using the Maxi Fuse puller
provided (Fig.3).
(Fig.4) Shows 50 amp fuse.
Place the top tank (waste-water) onto the machine (Fig.5) and connect the
vacuum
and floor-tool hose to the separator (Fig.6).
Fit the isolator key and switch the machine on (Fig.7).
Fill the bottom tank (clean-water) from a tap or hose pipe using the
Flexi-Fill pipe (Fig.8) or remove the filler cap from the rear left of the
machine and fill using a bucket (Fig.9). Add non-foaming cleaning fluid as
required (See page 28). The TTB 4045 / TTB 4055 / TTB 4552 all have a
water capacity of 40 Litres.
9
Great care must be taken to ensure that
contaminants (leaves, hair, dirt, etc.) are not
allowed to enter the clean-water tank during the
If using a bucket or similar, ensure it is
always clean and free from debris.
20
2
50Amp
4
Note:
filling process.
!
6