Switch Housing Assembly; Testing Your Fan - Ellington TAH52CB5 Installation Manual

9. Switch Housing Assembly.

Remove 1 screw from switch housing plate
(on underside of motor) and loosen the
other 2 screws.
Connect male plug from motor housing to
female plug from switch housing. Be sure
that plugs connect securely. Align slotted
holes in switch housing with loosened
screws in switch housing plate. Twist switch
housing to lock. Re-insert screw that was just
removed and securely tighten all 3 screws
with Phillips screwdriver.

10. Testing Your Fan.

It is recommended that you test fan before
finalizing installation. Restore power from circuit
box and light switch (if applicable). Test fan
speeds with pull chain. (diagram 1) Start at the
OFF position (no blade movement). First pull will
set the fan to HI. Second pull will set the fan to
MEDIUM. Third pull will set the fan to LOW.
Fourth pull will again set the fan to the OFF
setting. If fan does not function, please refer to
"Troubleshooting" section to solve any issues
before contacting Customer Service.
Turn fan completely off before moving the
reverse switch. Set reverse switch to recirculate
air depending on the season:
- LEFT position in summer (diagram 2)
- RIGHT position in winter (diagram 3)
A ceiling fan will allow you to raise your
thermostat setting in summer and lower your
thermostat setting in winter without feeling a
difference in your comfort.
Important: Reverse switch must be set either
completely RIGHT or completely LEFT for fan to
function. If the reverse switch is set in the middle
position (diagram 4), fan will not operate.
Attach pull chain extension supplied or custom
pull chain extension (sold separately) to the end
of the pull chain.
switch
housing
plate
plugs
reverse
switch
diagram 1
diagram 2
page 7
motor housing
switch housing
pull chain
extension
diagram 3
diagram 4