Blade Assembly; Motor Housing Assembly. Pgs - Ellington E-ROU54CH5LKRW Installation Manual

8. Blade Assembly.

Time Saver: Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate 15 blade attachment screws and
washers in one of the hardware packs. Hold
blade plate up to blade, aligning holes in
blade plate with holes in blade as shown, and
then lower blade arm over blade holes. Insert
3 blade attachment screws (along with
washers) with fingers first and then tighten
screws securely with a Phillips screwdriver.
Repeat for the remaining blades.
Remove blade arm screws and lock washers
from top of motor. Align blade arm holes with
motor screw holes and attach blade arm with
screws and lock washers. Before securing
screws permanently, repeat this procedure
with remaining blade arms. Secure all screws.
Note: Tighten blade arm screws twice a year.
9. Motor Housing Assembly.
Turn motor housing so that the flat side faces up.
Remove 1 screw from outer edge of motor housing
and loosen the other 2 screws.
Turn shade fitter so that the posts are facing up. Align
slotted holes in center of shade fitter with loosened
screws on motor housing. Twist shade fitter to lock.
Re-insert screw that was just removed and tighten all
3 screws with Phillips screwdriver.
blade
arm
screws
and lock
washers
blade
motor
shade fitter
page 7
blade attachment
screws and washers
blade arm
blade plate
screw
motor housing
screw
motor housing