Switch Housing Assembly; Testing Your Fan - Ellington MXW36ABZ5 Installation Manual

10. Switch Housing Assembly.

Remove 3 screws from fitter plate on underside
of motor. Connect male plug from motor
housing to female plug from switch housing.
Make sure plugs connect tightly.
Align holes in switch housing with holes in
fitter plate. Re-insert screws that were
previously removed and use a Phillips
screwdriver to secure all screws.

11. Testing Your Fan.

It is recommended that you test fan before
finalizing installation. Restore power from circuit
box and wall switch (if applicable). Test fan speeds
with pull chain. Start at the OFF position (no blade
movement). First pull will set the fan to HI. Second
pull will set the fan to MEDIUM. Third pull will set
the fan to LOW. Fourth pull will re-set the fan to
OFF setting. (diagram 1) If fan does not function,
please refer to "Troubleshooting" section to solve
any issues before contacting Customer Service.
Turn fan completely off before moving the reverse
switch (located on switch housing). Set reverse
switch to recirculate air depending on the season:
- DOWN position in summer (diagram 2)
- UP position in winter (diagram 3)
A ceiling fan will allow you to raise your thermostat
setting in summer and lower your thermostat
setting in winter without feeling a difference in
your comfort.
Important: Reverse switch must be set either
completely UP or completely DOWN for fan to
function. If the reverse switch is set in the middle
position (diagram 4), fan will not operate.
Attach pull chain extension supplied or custom
pull chain extension (sold separately) to end of the
pull chain.
switch
housing
plate
switch housing
reverse
switch
diagram 1
diagram 2
page 8
motor housing
male plug
female plug
motor housing
switch housing
pull chain
extension
diagram 4
diagram 3