Blade Assembly; Switch Housing Assembly - Ellington E-DER54ESP5CR Installation Manual

9. Blade Assembly.

Time Saver: Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate 15 blade attachment screws and
washers in hardware packs. Hold 1 blade plate
up to a blade and align holes, as shown, and
lower blade arm over blade holes. Insert 3 blade
attachment screws (along with washers) with
fingers first and then tighten screws securely
with a Phillips screwdriver. Repeat for the
remaining blades.
Remove blade arm screws and lock washers
from underside of motor. If plastic motor locks
are installed with blade arm screws, discard
plastic motor locks (save blade arm screws and
lock washers to secure blade arms). Align blade
arm holes with motor screw holes and attach
blade arm with lock washers and blade arm
screws. Before securing screws permanently,
repeat this procedure with remaining blade
arms. Securely tighten all screws.
Note: Tighten blade arm screws twice a year.

10. Switch Housing Assembly.

Remove 3 screws from outer edge of
switch housing plate (save screws for later
use).
Remove 1 screw from fitter plate (on
underside of motor) and partially loosen
the other 2 screws. Align slotted holes in
switch housing plate with loosened
screws in fitter plate, allowing wire
connectors from motor housing to come
through hole in middle of switch housing
plate. Twist switch housing plate to lock.
Re-insert screw that was previously
removed and tighten all 3 screws
securely.
Align holes on rim of switch housing with
holes in switch housing plate. Re-insert
screws that were previously removed
and securely tighten all 3 screws with a
Phillips screwdriver.
plastic
motor
lock
lock washer and
blade arm screw
fitter
plate
wire connectors
page 8
motor
housing
blade attachment
screws and washers
blade plate
motor housing
switch housing plate
switch housing
blade arm
blade