Fan Assembly. Pgs - Ellington E-LAV52BP4LK Installation Manual

5. Fan Assembly (with downrod).
If you wish to extend the hanging length of
your fan, you must remove the hanging ball
from the 6in. downrod provided to use with an
extended downrod (sold separately). [If you wish
to use the 6in. downrod, please proceed to
instructions following the dotted line below.]
To remove hanging ball, loosen set screw on
hanging ball, lower hanging ball and remove
stop pin. Slide hanging ball off the original
downrod, A, and slide it down the longer
downrod, B (the top of the downrod should be
noted as having a set screw hole; use this hole
when setting the set screw). Insert stop pin into
top of extended downrod and raise hanging
ball. Be sure stop pin aligns with slots on the
inside of the hanging ball. Tighten set screw
securely.
Tip: To prepare for threading electrical wires
through downrod, apply a small piece of
electrical tape to the ends of the electrical
wires--this will keep the wires together when
threading them through the downrod.
Loosen yoke set screws and nuts in motor
housing yoke and remove pin and clip from
motor housing yoke. Slide downrod through
canopy and yoke cover.
Thread safety cable and electrical wires through
downrod and pull extra wire slack from the
upper end of the downrod.
Thread downrod into the motor yoke until
holes for pin and clip in downrod align with
holes in yoke--make sure wires do not get
twisted. Re-insert pin and clip. Tighten yoke set
screws and nuts securely. Lower yoke cover to
motor housing.
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and
instructions appearing in the manual are not
meant to cover all possible conditions and
situations that may occur. It must be understood
that common sense and caution are necessary
factors in the installation and operation of this fan.
set screw
A
electrical wiring
yoke cover
clip
page 4
set screw hole
stop pin
hanging ball
B
safety cable
downrod
canopy
yoke set screw
motor
housing
pin