Listing Of Encoder Commands And Prompts - DEVA Broadcast SmartGen Micro Maintenance And Operation Instruction Manual

Listing of Encoder Commands and Prompts

Command Description
Program Identification, 4 digit HEX number (station "digital address")
PI
PS Program Service Name, 8 (max) ASCII characters (station "street name")
Dynamic PS, 64 (max) ASCII characters (for messaging in PS field)
DPS
DPSS Dynamic PS speed, 0 to 9 (0 = OFF, 1 = SLOW, 9 = FAST)
PTY Program Type, 0 to 31 (describes station format)
Traffic Program, 0 or 1 (0 = NO, 1 = YES)
TP
Traffic Alert, 0 or 1 (0 = flag OFF, 1 = flag ON)
TA
DI Decoder Information, 0 to 15
MS Music/Speech, 0 or 1 (0 = speech-only, 1 = music)
TEXT RadioText, 64 (max) ASCII characters
DRTS Dynamic RadioText Speed, 0 to 9 (0 = OFF; 1 = SLOW 9 = FAST)
AFx Alternative Frequencies List using method A, where x is from 1 to 7
0 = blank; 1 to 204 = "channel" in 87.6MHz to 107.9MHz
Example: AF1=10
TATIME TA Timeout, 0 to 255 minutes (0 = OFF)
ECHO Command Echo, 0 or 1 (0 = ECHO OFF, 1 = ECHO ON)
PARSE Dynamic PS Method, 0 to 9
0 = centered, 9 = left justified, 1-8 = N characters at a time
MODE Operating Mode, 0 or 1 (LOOP or SIDE) 0 = loop-through, 1 = sidechian
TIME UTC Time, HH:MM:SS (HH=hour, MM=Minutes, SS=Seconds)
DATE Date, DD.MM.YY (DD=Day, MM=Month, YY=YEAR)
OFFSET Local Time offset, -15:30 to +15:30, in multiples of half hours
PHASE RDS subcarrier Phase in degrees, 0 to 3599, 1 = 0.1 degree
CT Switch transmission of 4A group ON or OFF, 0 = OFF, 1 = ON
Use '=' to SET parameter value, e.g.: PI=1234
Use '?' to GET parameter value, e.g.: TIME?
Command Description
?? Returns all data in encoder memory
SER? Returns device serial number
Returns firmware & hardware revision numbers
REV?
PILOT? Returns the Status of the 19 kHz PLL.
LOCK - locked to the 19kHz stereo pilot signal.
FREE - defaulted to the internal timebase
RESET Resets the encoder as if AC power were cycled off and on
INIT Initializes the encoder to all factory defaults
CLS Clears the Terminal Screen
Response Meaning
OK Command received by encoder properly formatted and understood
NO Command properly formatted but data not understood
(NONE) Data sent is ignored by the encoder
DON'T FORGET
be entered or changed easily through the Windows
SPECIAL COMMANDS
that all the static RDS registers, including simple scrolling messages, can
- 46 -
65 Aleksandar Stamboliyski Str., 8000 Bourgas, Bulgaria
Tel: +359 56 820027, Fax: +359 56 836700
E-mail: office@devabroadcast.com ,Web: www.devabroadcast.com
®
data entry screens.