Power-Up - DEVA Broadcast SmartGen Micro Maintenance And Operation Instruction Manual

POWER-UP

Once the encoder is connected and powered-up, communications should be automatic. A
notation at the bottom of the HyperTerminal screen verify connection.
Type: ??8 . This will cause the encoder to send back the contents of all ID, flag and message
registers, which (shown here) are the data entered previously (see "Hardware & RDS Configuration"
on page 35). ?? can be used at any time to make the encoder 'spill its guts'. This exercise does not
interrupt or interfere with encoder operation.
All valid interrogations are followed by: OK; a NO shows that the interrogation was not valid.
Any single parameter in a register can be interrogated independently. Simply type the register
designation followed by a single question mark. A response shown at the right for the typed
command: PI?8
65 Aleksandar Stamboliyski Str., 8000 Bourgas, Bulgaria
Tel: +359 56 820027, Fax: +359 56 836700
E-mail: office@devabroadcast.com ,Web: www.devabroadcast.com
- 41 -