Encoder Housekeeping Commands; Register Interrogation; Encoder Initialization; Encoder Reset - DEVA Broadcast SmartGen Micro Maintenance And Operation Instruction Manual

Basic rds/rbds encoder with usb connectivity

Hide thumbs Also See for SmartGen Micro:

Table of Contents

Encoder Housekeeping Commands

Typing: ??8 returns the status of all flag and ID settings and the contents of static message

buffers to the screen. This was illustrated in section "Power-Up" on page 41".

The "initialize" command is invoked by typing: INIT8 . This is used to reestablish encoder

operation in the unlikely event of an internal software 'crash,' or for any other reason to restore

all the factory defaults (see "Factory Defaults" on page 47). INIT8 is an emergency recovery

command only. It is not necessary to execute INIT8 prior to updating any encoder programming.

Typing: RESET8 initiates a 'hardware reset' equivalent to turning the encoder off and back on

again. This reset command does not clear the registers of programming commands that have been

saved as described above.

Type: REV?8 for a display of the encoder's firmware version. This might prove important in

determining whether differences exist between SmartGen Micro encoders purchased at different

times.

65 Aleksandar Stamboliyski Str., 8000 Bourgas, Bulgaria

Tel: +359 56 820027, Fax: +359 56 836700

E-mail: office@devabroadcast.com ,Web: www.devabroadcast.com

- 45 -

Table of Contents