Table of Contents
Advertisement
Once the programming software has been installed on the computer, a special USB port driver
must also be installed if that particular computer is ever to address the encoder through the front-
panel USB port. The station's 'utility laptop' or other machine used for quick, local encoder
programming must have both the programming software and the USB driver installed.
When the programming software was installed, the USB driver was put into a folder within the
SmartGen Micro program file. With a normal installation (as described above) under Windows
XP, the driver will have been located here: My Computer \ Local Disk (C:) \ Program Files \
SmartGen Basic Encoders Manager \ Drivers.
Installing The USB Port Driver under Windows
1. With the SmartGen Micro Encoder powered-up, connect the front-panel USB port to the
computer using the cable supplied. This should immediately bring up a New Hardware notification
above the computer Taskbar and start the Found New Hardware Wizard. Select "Install from a list
or specific location (Advanced)" and then: Next>.
65 Aleksandar Stamboliyski Str., 8000 Bourgas, Bulgaria
Tel: +359 56 820027, Fax: +359 56 836700
E-mail: office@devabroadcast.com ,Web: www.devabroadcast.com
- 28 -
®
®
XP
Advertisement
Table of Contents
