Power-Up - DEVA Broadcast SmartGen Mini Maintenance And Operation Instruction Manual

Compact rds/rbds encoder with lan & usb connectivity

Table of Contents

POWER-UP

Once the encoder is connected (by the TCP/IP port) and powered-up, communications should

be automatic. A notation at the bottom of the HyperTerminal screen verify connection.

Type: RDS?8

. This will cause the encoder to send back the contents of all ID, flag and

message registers, which (shown here) are the data entered previously. RDS? can be used at any

time to make the encoder 'spill its guts'. This exercise does not interrupt or interfere with encoder

operation.

All valid interrogations are followed by: OK; a NO shows that the interrogation was not valid.

Any single parameter in a register can be interrogated independently. Simply type the register

designation followed by a single question mark. A response shown at the right for the typed

command: PI?8

65 Aleksandar Stamboliyski Str., 8000 Bourgas, Bulgaria

Tel: +359 56 820027, Fax: +359 56 836700

E-mail: office@devabroadcast.com ,Web: www.devabroadcast.com

- 35 -

Table of Contents

Do you have a question about the SmartGen Mini and is the answer not in the manual?