Step 6: Connecting The Cables - Roland TrueVIS VG-640 Setup Manual

3. Assembly and Ink Filling
Step 6 : Connecting the Cables
Procedure
A
Insert the cable clamp.
B
Connect both the power cord and the Ethernet cable (commercially available).
Use a power plug adapter if the electrical outlet is a two-prong outlet.
WARNING
WARNING
WARNING
Ethernet cable
(Category 5 or higher)
16
Perform this task with all power switches left switched off.
Failure to observe this instruction may cause the machine to move suddenly,
resulting in injury.
Connect the machine to an electrical outlet that complies with this ma-
chine's ratings (for voltage, frequency, and current).
Incorrect voltage or insufficient current may cause fire or electrical shock.
Connect the machine to ground.
This can prevent fire or electrical shock due to current leakage in the event of
a malfunction.
Cable clamp
Pass the power
cord through here.
Ethernet
(1000BASE-T
recommended)
Power cord