Detection By Both Layer And Length - Fujitsu fi-6000NS Operator's Manual

A.5.3 Detection by both Layer and Length
If [Both] is selected in
detected by both layer and length.
In this case, set sheets of the same thickness and length in the ADF at any one time.
• Document thickness: 0.065 to 0.15mm
• Document length deviation: 1% or less
• Punched holes are not allowed within 35mm (1.4in) of the vertical center line of the docu-
ment.
• Do not glue on any other paper within 35mm (1.4in) of the vertical centerline of the docu-
ment.
ATTENTION
Area where multifeed detection is possible
Feed
direction
"4.8.13 Multifeed Detection (Layer and Length)" (page
•
Multifeed detection by layer will often mis-detect very thick paper or plastic
documents. When scanning such documents, select "None" on the "Multi-
feed Setup" screen.
•
Multifeed may not be detected for the top and bottom 25mm of a document.
Front side
35mm
Center of paper
Network Scanner fi-6000NS Operator's Guide
256), mulifeeds are
Page top
Page bottom
329
A