Detection By Both Layer And Length - Fujitsu iScanner fi-6010N Operator's Manual

A.5.3 Detection by both Layer and Length
If [Both] is selected in
detected by both layer and length.
In this case, set sheets of the same thickness and length in the ADF at any one time.
Document thickness: 0.065 to 0.15mm
Document length deviation: 1% or less
Punched holes are not allowed within 17.5mm (0.7in) either side of the center of paper.
Do not glue on any other paper within 17.5mm (0.7in) either side of the center of paper.
ATTENTION
Area where multifeed detection is possible
Feed
direction
"6.9.17 Multifeed Detection (Layer and Length)" (page
Multifeed detection by layer will often mis-detect very thick paper or plastic
documents. When scanning such documents, select "None" on the "Multi-
feed Setup" screen.
Multifeed may not be detected for the top and bottom 25mm of a document.
17.5mm
Front side
17.5mm
Page top
Page bottom
Center of paper
fi-6010N Network Scanner Operator's Guide
343), mulifeeds are
429
A