Fujitsu fi-6000NS Operator's Manual page 401

Screen
Print (If Shrink to Fit is selected, the
scanned data is reduced to fit the print-
able area of the paper. If the scanned
data is smaller than the printable area,
it is printed at 100%.)
(If 100% is selected, the scanned data
is printed at 100%. If the scanned data
is larger than the printable area, only
part of it will be printed.)
Network is busy. Try again later.
User name or password may be incor-
rect.
Cannot find the network printer path.
Not connected to the network.
Scan&Buffer job is already queued on
the computer that owns the specified
network printer.
Access was refused.
Network path is too long.
Message
Network Scanner fi-6000NS Operator's Guide
Action
No action required.
No action required.
Wait for a while, and try again.
Re-enter the user name and pass-
word.
Contact a server administrator.
Check that the system network is
functioning normally by perform-
ing a ping test from
another machine in the network,
other than the server with network
printer. If the system network is
not operating correctly, refer to
"Failure to connect to a server
using its IP address" (page 305)
further solutions.
Try the following:
• Select a different network
printer.
• Wait a short time, then try
again.
Access was refused. Contact a
server administrator to find out if
an access permit has been set.
Try the following:
• Set a shorter printer alias.
• Contact a system administrator
to have the network path short-
ened.
C
for
373