Output Stage Vr2 - Permobil K Service Manual

Output stage

Output stage VR2

Removal
1. Switch off the main power switch on the control panel.
2. Remove the chassis covers. See page 8.
3. Disconnect the electrical connections from the output stage. Note their positions (see illustration
below).
Motor 1
Left
4. Remove the output stage by unscrewing its two
mounting screws. See the figure. On a chassis
fitted with lights, remove the lights module. See
page 39.
Assembly
Assemble in the reverse
1. Fit the Power Module with the two nuts (see
fig. above).
2. Connect the electrical connections to the Power
Module. Note their positions (see fig. above).
3. Fit the chassis covers. See page 8-9.
4. Switch the main fuse to ON. See page 42.
Batteri
Output stage cable connections. (VR2)
order.¨
Motor 2
Right
The output stage is fitted with two screws.
38 38
Control Panel
Inhibit
External
charging socket
Actuator