Install The Access Panel - HP proliant ml350 gen9 User Manual

WARNING:
internal system components to cool before touching them.
CAUTION:
expansion slot covers, or blanks installed.
Power down the server (on page 23).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
If the server is in a tower configuration, do the following:
3.
Unlock and remove the tower bezel.
a.
Place the server on the side.
b.
If the server is in a rack configuration, extend the server from the rack.
4.
Open the access panel latch, slide the access panel to the rear of the chassis, and then remove the
5.
access panel.
If the access panel latch is locked, use a T-15 Torx screwdriver to unlock the latch.

Install the access panel

Place the access panel on top of the server with the hood latch open. Allow the panel to extend past the
1.
rear of the server approximately 1.25 cm (0.5 inch).
Push down on the hood latch. The access panel slides to a closed position.
2.
To reduce the risk of personal injury from hot surfaces, allow the drives and the
For proper cooling do not operate the server without the access panel, baffles,
Operations 25