Remove The Optical Drive - HP proliant ml350 gen9 User Manual

IMPORTANT:
be removed. To prevent an orderly or immediate server shutdown, HP highly recommends
powering down the server during these procedures. To determine if powering down is required,
see the specific procedure.
IMPORTANT:
information, refer to the fan locations table
To remove the component:
Power down the server (on page 23).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Remove the access panel (on page 24).
3.
Remove the fan cage (on page 29).
4.

Remove the optical drive

The server supports both DVD-ROM and DVD-RW drives.
Power down the server (on page 23).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
If the server is in a tower configuration, do the following:
3.
Unlock and remove the tower bezel (on page 24).
a.
Place the server on its side.
b.
Remove the access panel (on page 24).
c.
If the server is in a rack configuration, do the following:
4.
When installing or replacing server components, one or more fans might need to
For optimum cooling, install fans in all primary fan locations. For more
("Hot-plug fans" on page 21).
Operations 30