Parts Supplied; Cavity Preparation - Fisher & Paykel DD605 Installation Instructions Manual

PARTS SUPPLIED

3
Drain hose Drain hose Wire clip (2)
support (1) joiner (1)
If the Drain hose(s) supplied are not long enough to reach your services, you must use a Drain Hose Extension Kit P/N 525798 which will extend the drain hose(s) by 3.6m. The kit is available from the nearest Fisher & Paykel
Authorized Service Agent, or Toll free 1.888.936.7872 or www. sherpaykel.com.

CAVITY PREPARATION

4
Important!
Be sure the edges of the services hole are smooth or covered. If the services
hole is through a metal partition the hole must be protected with the Edge
Protector supplied to prevent damage to the power cord or hoses.
These marks indicate mounting tab screw locations
*
Preferred position. If adequate clearance, services hole can be
higher to clear toekick space.
If hole is higher, ensure drain hose(s) are routed straight into the
waste connection.
Note: Services can be located either side of DishDrawer®.
Water Pressure Max
Water softener models 1 MPa (145 psi)
Other models 1 MPa (145 psi)
Drains will need to be separated to satisfy kosher requirements. We suggest you con rm
acceptability with your local rabbi in respect to kosher installations.
Max. distance of
Left hand Right hand
hoses and cord from
side side
chassis edge
Drain hose
79" 71"
(2011 mm) (1794 mm)
Inlet hose
61" 53"
(1561 mm) (1344 mm)
Power cord
70" 61"
(1776 mm) (1559 mm)
Clamp (1) Install Phillips
tabs (2) 16 mm
screws (9)
If no side partition, use a
brace for securing.
2" x 4"
Min
0.1 MPa (14.5 psi)
0.03 MPa (4.3 psi)
Left hand Right hand
side side
Washer (1) Moisture protection Edge Protector (1)
tape (1) (if service hole
(to prevent moisture partition is metal)
damage)
Moisture protection
tape must be applied.
(10 mm)
max. ø ½
1 "
(38 mm)
*
Hexagonal Pre nished toe kick (1)
socket (2)
White or Black
(Long & Short)
max.
17 "
(450 mm)
min.
(200 mm)
*
110-120 VAC
max. 15 A
7 "