Care And Maintenance - Hotpoint Ariston H64IL9PAA S SK Operating Instructions Manual

Care and maintenance

Switching the appliance off
Disconnect your appliance from the electricity supply before
carrying out any work on it.
Cleaning the oven
! Never use steam cleaners or pressure cleaners on the
appliance.
• Clean the glass part of the oven door using a sponge
and a non-abrasive cleaning product, then dry
thoroughly with a soft cloth. Do not use rough abrasive
material or sharp metal scrapers as these could
scratch the surface and cause the glass to crack.
• The stainless steel or enamel-coated external parts and
the rubber seals may be cleaned using a sponge which
has been soaked in lukewarm water and neutral soap.
Use specialised products for the removal of stubborn
stains. After cleaning, rinse and dry thoroughly. Do not
use abrasive powders or corrosive substances.
• The inside of the oven should ideally be cleaned after
each use, while it is still lukewarm. Use hot water and
detergent, then rinse well and dry with a soft cloth. Do
not use abrasive products.
• The accessories can be washed like everyday
crockery, and are even dishwasher safe.
• Dirt and grease should be removed from the control panel
using a non-abrasive sponge or a soft cloth.
Stainless steel can be marked by hard water that
•
has been left on the surface for a long time, or by
aggressive detergents that contain phosphorus. We
recommend that the steel surfaces are rinsed well then
dried thoroughly.
Inspecting the oven seals
Check the door seals around the oven regularly. If the seals
are damaged, please contact your nearest After-sales
Service Centre. We recommend that the oven is not used
until the seals have been replaced.
Replacing the oven light bulb
To replace the oven light bulb:
1. Remove the glass cover using a screwdriver.
Cavity
Light bulb
Seal
Cover
! Do not use the oven lamp as/for ambient lighting.
Cleaning the glass ceramic hob
! Do not use abrasive or corrosive detergents (for example,
products in spray cans for cleaning barbecues and ovens),
stain removers, anti-rust products, powder detergents or
sponges with abrasive surfaces: these may scratch the
surface beyond repair.
• It is usually sufficient simply to wash the hob using a damp
• If the hob is particularly dirty, rub it with a special glass
• To remove more stubborn dirt, use a suitable scraper (this
• If plastic or sugary substances have accidentally been
• Once it is clean, the hob may be treated with a special
• Always remember to rinse the appliance well with clean
2. Unscrew the light
bulb and replace it
with a similar one:
Wattage 15 W, cap
E 14.
Replace the glass
c o v e r , m a k i n g
sure the seal is
positioned correctly
(see diagram).
sponge and dry it with absorbent kitchen roll.
ceramic cleaning product, then rinse well and dry
thoroughly.
is not supplied with the appliance). Remove spills as soon
as possible, without waiting for the appliance to cool, to
avoid residues forming crusty deposits. You can obtain
excellent results by using a rustproof steel wire sponge -
specifically designed for glass ceramic surfaces - soaked
in soapy water.
melted on the hob, remove them immediately with the
scraper, while the surface is still hot.
protective maintenance product: the invisible film left
by this product protects the surface from drips during
cooking. This maintenance should be carried out while
the appliance is warm (not hot) or cold.
water and dry it thoroughly: residues can become
encrusted during subsequent cooking processes.
Glass ceramic hob cle-
aners
Window scraper Razor
blade scrapers
Replacement blades
COLLO luneta
HOB BRITE
Hob Clean
SWISSCLEANER
Available from
DIY Stores
DIY Stores,
supermarkets,
chemists
Boots, Co-op stores, de-
partment stores, Regional
Electricity Company shops,
supermarkets
23
GB