Snmp - TP-Link TL-WR802N User Manual

configure the corresponding function. The detailed explanations for each submenu are provided
below.

5.9.1 SNMP

Choose menu "System Tools → SNMP", and then you can get the SNMP settings in the
following screen.
SNMP Agent - Choose Enable to open this function if you want to have remote control

through SNMPv1/v2 agent with MIB-II. Choose Disable to close this function.
SysContact - The textual identification of the contact person for this managed node.

SysName - An administratively-assigned name for this managed node.

SysLocation - The physical location of this node.

Get Community - Enter the community name that allows Read-Only access to this device's

SNMP information. The community name can be considered a group password. The default
setting is public.
Get Source - Get source defines the IP address or subnet for management systems that can

read information from this 'get' community device.
Set Community - Enter the community name that allows Read/Write access to this device's

SNMP information. The community name can be considered a group password. The default
setting is private.
Set Source - Set source defines the IP address or subnet for management systems that can

control this 'set' community device.
Click the Save button to save your settings.
TL-WR802N
Figure 5-26 SNMP Settings
- 122 -
300Mbps Wireless N Nano Router