Dhcp Client List - TP-Link TL-WR802N User Manual

amount of time in minutes and the user will be "leased" this dynamic IP Address. After the
time is up, the user will be automatically assigned a new dynamic IP address. The range of
the time is 1 ~ 2880 minutes. The default value is 120 minutes.
Default Gateway (Optional) - It is suggested to input the IP address of the LAN port of the

Router. The default value is 192.168.0.254.
Default Domain (Optional) - Input the domain name of your network.

Primary DNS - (Optional) Input the DNS IP address provided by your ISP or consult your

ISP.
Secondary DNS (Optional) - Input the IP address of another DNS server if your ISP

provides two DNS servers.

Note:
1. To use the DHCP server function of the Router, you must configure all computers on the LAN
as "Obtain an IP Address automatically".
2. When you choose the Smart IP (DHCP) mode in Network → LAN, the DHCP Server function
will be disabled. You will see the page as below.

6.8.2 DHCP Client List

Choose menu "DHCP → DHCP Client List", and then you can view the information about the
clients attached to the Router in the screen as shown in Figure 6-23.
TL-WR802N
Figure 6-22 DHCP Settings
- 149 -
300Mbps Wireless N Nano Router