Step 7, Level Refrigerator On; Step 8, Install Toekick And Vent - Monogram ZKST300N Design Manual With Installation Instructions

30" built-in bottom-freezer, 2-drawer refrigerator
Table of Contents

Advertisement

Available languages

Available languages

Installation Instructions
STEP 7_ | LEVEL REFRIGERATOR
All rnodels have 4-point leveling. The front is supported
by leveling legs; the rear is supported by adjustable
wheels. Both are accessible from the front of the
refrigerator.
@ To level the back of the refrigerator, turn the 5/16" hex
nut located above the front wheels. Turn counter
clockwise to raise or clockwise to lower the
refrigerator.
« For front leveling, use a 1-5/16" open-end wrench.
* Adjust height of refrigerator to match installation
cutout opening. The refrigerator should be level and
plumb with cabinetry.
Hex Nut
Adjusts Rear
Wheels
A CAUTION:
The rear leveling wheels and front leveling legs are
limited to a maximum height adjustment of 1". If the
installation requires more than 84-1/2" height, the
installer should elevate the refrigerator on a sheet
of plywood or runners. Cabinetry trim could also be
added across the top of the opening to shorten the
opening.
If you attempt to raise the refrigerator more than 1",
you will damage the front leveling legs and the rear
leveling wheels.
16
STEP 8
|INSTALL TOEKICK AND VENT
¢ Locate the toekick, vent and screws (removed earlier).
e A custom toekick can be installed to match or
complement the surrounding cabinetry. Use the
supplied toekick as a template.
¢ Reinstall the vent using the screws removed earlier.
¢ Reinstall the toekick .
Toekick Holes
SSeS
Sa
_————
SS
GSS eae
SES
¢
SSS
Ss
=
Vent Hales
fo
Supplied Toekick

Advertisement

Table of Contents
loading

Table of Contents