Step 14 Install Toekick; Inspect Final Installation - Monogram ZIP360NH Installation Instructions Manual

STEP 14 INSTALL TOEKICK

• Locate the supplied toekicks (shipped taped to the
side of the refrigerator.
• The narrower set of toe kicks will be used with
standard installation. You can discard the other set of
toe kicks.
• Install the toekick assembly with the 2 screws
provided, adjust to the desired height and tighten the
screws.
IMPORTANT: A custom toekick can be installed to
match or complement the surrounding cabinetry but
can NOT cover the horizontal vent slots of the factory
toekick.
Installation Instructions
21

INSPECT FINAL INSTALLATION

Check door alignment
Stand back away from the refrigerator to inspect the
final installation.
• Installation or the addition of heavy door panels
may have caused the doors to move slightly out of
alignment. Check to be sure the top of the doors are
evenly aligned with each other. If necessary, the doors
may be adjusted up or down to align.
• Add or subtract shims as shown to adjust the right
door only. More shims are located under the hood on
the left side in the bag with the filter bypass plug and
mini manual.
To Raise Right Hand Door
• Lift the right hand door up so there is a gap below the
bottom hinge bushing.
• Snap a shim onto the hinge pin below the bushing.
• Lower the door and re-check the alignment.
• Repeat as necessary.
To Lower Right Hand Door
• Lift the right hand door up so there is a gap below the
bottom hinge bushing.
• Remove a shim by pushing shim off of the hinge pin.
• Lower the door and re-check the alignment.
• Repeat as necessary.
Bag location
Shim